Choosing a Machine

Which machine fits your floor, your square footage and your budget.

Choose a rider for a large, open floor you want cleaned in fewer operator hours. Choose a walk-behind for smaller areas, crowded aisles and rooms you clean one at a time. Every FactoryCat rider covers more floor per hour than any FactoryCat walk-behind: up to 18,000 to 29,374 sq ft per hour against up to 7,308 to 15,784 (practical rates, ISSA 2010 cleaning times).
Choose by what is on your floor: a sweeper for dry debris, a scrubber for wet or stuck-on soil, a sweeper-scrubber only when you get both every day. FactoryCat builds no sweeper-scrubber with a built-in sweeper; its cylindrical-deck scrubbers sweep light debris while scrubbing. For heavy dry debris, the TR sweeper covers up to 59,406 sq ft per hour (practical rate, ISSA 2010 times), twice FactoryCat's largest scrubber.
A stand-on scrubber is the middle ground: the operator rides standing, so it usually travels faster than a walk-behind and is quicker to step off than a seated rider. FactoryCat's stand-on, the Rebel, cleans a 20-inch path, the same as the 20-inch option on its smallest walk-behinds. Pick it for stop-and-go work in busy aisles, a walk-behind for small rooms, and a rider for big open floors.
Divide your cleanable floor area by the hours you have, then pick a machine whose practical rate beats that figure. FactoryCat walk-behinds have practical rates of up to 7,308 to 15,784 sq ft per hour and FactoryCat riders up to 18,000 to 29,374, based on ISSA 2010 cleaning times. A faster machine finishes sooner, but it has to fit your narrowest doorway and last the job on one charge.

Decks, Brushes & Pads

Deck types, brush and pad choices, and what each one is good at.

Yes, an orbital scrub deck can strip floor finish with water and no stripper chemical, because its pad scrubs in small, fast orbits instead of spinning. FactoryCat offers an orbital deck on six scrubbers and lists a "Reduction in Water Usage" for it. The trade-off is time and pad wear, and very heavy build-up can still need a chemical strip, so test a small area first.
Pick a disk deck for wavy or smooth finished floors, a cylindrical deck for grouted tile or small loose debris, and an orbital deck to strip floor finish without chemicals. FactoryCat sells all three: disk on every scrubber, cylindrical on six models, orbital on six. Orbital tops out at a 32-inch scrub path and is not offered on the two largest riders.
Use pads on smooth, finished floors such as sealed VCT, and brushes on textured, grouted, uneven or bare concrete floors, where bristles reach low spots. On a FactoryCat scrubber, the disk deck takes either, the orbital deck takes pads, and the cylindrical deck takes brushes only, in five of the nine options FactoryCat lists. Rougher grades clean harder but wear the finish and load the motor more.

Floor Types & Applications

Setting a machine up for a specific floor or a specific job.

Scrub forklift tire marks off bare warehouse concrete with a floor scrubber, a grit brush, a detergent made for rubber marks and slow, overlapping passes. The marks are rubber smeared on by heat and friction, so a mop glides over them. Start with Light Grit, the mildest of FactoryCat's four grit grades, but on polished, sealed or coated concrete, start with a pad and test a small area first.
For VCT, scrub daily with a red pad on a disk deck, and use an orbital deck for recoat prep or to strip finish with water and no stripper chemical. Six FactoryCat scrubbers offer that deck: a walk-behind for up to 31,568 sq ft in a 2-hour window at practical rates, the Pilot or GTX rider above that. Any pad rougher than red starts cutting finish.

Batteries, Options and Upgrades

Power choices, battery care and what a machine costs to keep running.

Choose AGM if your scrubber's daily scrubbing fits in one charge and it charges fully overnight. Choose lithium if it needs top-ups during the day to keep going, and you can pay more up front. On FactoryCat machines, lithium is offered only on the four rider scrubbers, at up to 160 Ah (Pilot) or 240 Ah (GTX, GTR and XR); walk-behinds take WET (flooded) or AGM.